Concrete Contractor in French Valley, CA - Level Slabs That Drain Right
Prime Perris Concrete is a concrete contractor based in Perris, CA, pouring driveways, patios, slabs and footings for homes and small properties in French Valley. We check grade, base and joint layout before the concrete arrives.
- Licensed and insured.
- Free quotes on site.
- We respond within 1 business day.
French Valley homes and the concrete around them
French Valley is unincorporated Riverside County, and most of the homes here are lived in by the people who own them. Many sit in newer subdivisions with two-car driveways, narrow side yards and backyards that came with a small builder's slab or bare dirt. Most of what we pour here is flatwork, the driveways, patios and walks that lie flat on the ground, along with pads for sheds and footings for walls. We do the same kind of work in Temescal Valley and in Perris, where we're based.
Lots here often sit on graded slopes, so the first thing I look at is where the water goes. A slab that falls even slightly toward the house sends every rain and every sprinkler run against your foundation, and that gets fixed in the grade we set, not in the finish.
Concrete services we pour in French Valley
Concrete driveway building
Driveways here often sink at the garage lip or crack where nobody cut a joint. We dig out, pack the base and repour so it stays level.
Concrete patio construction
Plenty of backyards here came with a small builder's slab or bare dirt. We pour patios sized for how you use the yard, sloped away from the house.
Stamped concrete services
Stamped concrete gives a patio, walk or front entry the look of stone or tile in one pour, with the same base and joint work underneath.
Concrete sidewalk building
Side-yard walks and paths to the gate take a lot of foot traffic on family homes here, so we pour them with a textured finish for grip.
Garage floor concrete
A cracked or uneven garage slab can be cut out and repoured, with the pitch set so water runs out the door instead of toward the walls.
Decorative concrete
Color, exposed aggregate and borders let a front walk or patio match the house, while the packed base underneath stays the same as any slab we pour.
Concrete retaining walls
Graded lots here often need a wall to hold back a slope or level part of the yard. We set the footing and the drainage behind it first.
Concrete floor installation
Interior slabs for additions, workshops and storage buildings on your property, poured level, with the base packed and checked before the truck arrives.
Concrete pool decks
Pool decks here take sun, splash water and bare feet all day, so we slope them toward the drains and give them a finish that isn't slick.
Concrete steps construction
Front entries and slope changes in a backyard often need a few steps. We form them with even risers so nobody catches a toe on the way up.
Slab foundation building
A slab for a garage, workshop or accessory building on your lot, with the ground packed and the forms checked against the plans before we pour.
Foundation installation
New foundations for additions and outbuildings on homes and small properties here, formed and checked against the plans the way I learned on commercial jobs.
Concrete parking lot building
Small business and rental properties in the area need lots that drain and stand up to cars turning on them. We set the grade first, then pour.
Concrete footings
Footings carry walls, patio covers and posts. We dig them to the depth the plans call for and check every one before any concrete goes in.
Foundation raising
When part of a slab or foundation has dropped, we find out why first, usually water or a soft base, before we lift it back into place.
Concrete cutting
Clean saw cuts for a new doorway, a plumbing trench, a patio extension, or control joints on an older slab that never got them cut.
Get a written concrete estimate for your French Valley home
We reply within one business day to set a time. I come out, measure and write you a free estimate on site, line by line, and there's no obligation to go ahead.
(951) 418-3042- Based in
- Perris, CA 92570
- Hours
- Mon–Fri: 8 AM–9 PM, Sat–Sun: 6 AM–9 PM
Working in French Valley under county permits
French Valley has no city government, so building permits here come from the Riverside County Building & Safety Department, and when a job needs one, the county's review sets our start date. When we take the permit out, we handle the paperwork with the county ourselves. If you're comparing contractors, ask each one for a state license number. Don't ask for a county business license, because the county doesn't issue one in unincorporated areas, and businesses here register for its Stormwater Compliance Program instead.
On these streets, plenty of backyards sit behind block walls with only a side gate, so part of every visit is working out whether the truck chute reaches or we need to pump or wheel the concrete in. That access, along with how much old concrete and soft dirt has to come out, is what moves the price most here, and you see your own figure on the written estimate. The schedule turns on the permit, if there is one, and on the weather the week of the pour. We work the same way in Murrieta and Menifee.
Wind, heat and builder slabs on French Valley lots
Hot, dry Santa Ana winds come through Riverside County every year, and wind like that pulls water out of the top of a fresh slab faster than the inside, which leaves a weak, dusty surface. We pour early in the day and keep the slab damp through curing, the days it needs to gain strength before you load it.
A lot of the cracked and sunken flatwork we get called about here sat on a subgrade, the ground the slab rests on, that was raked level instead of dug out and packed. The base is the part you can't see on day one, so it's the first thing a tight budget cuts. I'd rather you skip the fancy finish than skimp on the base, because a nice surface on settling dirt just cracks in a nicer pattern, and a plain slab on a packed base stays where we put it.
How a concrete job runs when you call us from French Valley
Here's what happens from your first call to the day the forms come off, and you deal with me at each step.
Call or send the form
Tell us what you want poured or fixed, and we set a time for me to come out. It helps if you're home so I can ask how you'll use the space.
I measure and check drainage
I measure, look at where the water runs and check what's under the old slab if there is one. You get a written estimate with every line spelled out, so you see what's in the price and what isn't.
We sort out the permit
If the job needs a county permit, we take it out before we set a pour date, because the county's review, not our calendar, decides when we can start. If you'd rather pull it yourself as the owner, we'll tell you early what we need from you.
Pour day with me on site
Before the truck arrives, our crew and I check the forms, the base and the joint layout one more time. After we finish, we tell you how long to stay off it on foot and with a car.
Questions about concrete work in French Valley
How do I find out if my concrete project needs a permit in French Valley?
Call the county's Building & Safety Department at (951) 955-1800 and describe the job, because the county's permit list doesn't settle plain flatwork like a driveway or patio either way. Its flyer names structural repairs, garages, carports, retaining walls and fences over 6 feet among the work that needs one. I'll check your job with them before we price it.
Does a concrete contractor need a California license to work in French Valley?
Yes, whenever the project needs a building permit, uses any additional workers, or totals $1,000 or more in labor and materials, counted across one or more contracts on the same project. Ask for the license number before you sign anything. We're licensed and insured.
Does a shed pad or a block wall need a permit in French Valley?
A one-story storage shed or playhouse up to 120 square feet of floor area is exempt under the county building ordinance, and so are fences up to 7 feet, except block walls over 4 feet high. The county's permit flyer lists sheds over 120 square feet of roof area and fences over 6 feet as needing one, so the two don't line up exactly. That's why we confirm with the department before we form a wall or pad.
Which building code applies to a new concrete permit in French Valley?
Permit applications completed on or after January 1, 2026 go under the 2025 California Building Codes, and ones completed before that date follow the code in effect when they were filed. A project you apply for now falls under the 2025 codes, and that's what we build to.
What causes new concrete to crack in French Valley?
Besides a soft base, most cracks come from a pour in midday heat or control joints cut late or skipped. Control joints are grooves cut partway into the slab so that when it shrinks and cracks, it cracks along a line we chose. All concrete can crack, so we also set rebar, steel bars inside the slab, where it needs to hold together if it does.
What affects the cost of a concrete driveway in French Valley?
The size and thickness of the slab, how much old concrete and dirt has to come out, how far the truck can reach, any rebar and the finish set most of the price. A broom finish, the light brushed texture that gives tires and shoes grip, costs less than stamped or colored concrete, and tearing out an old driveway adds demolition and haul-off. Each of those shows up as its own line on your written estimate.
Perris, CA
Get your French Valley slab measured right
If you call before you settle on a finish, I can show you on your own lot where the money should go first.